RADIO MODIFICATIONS ALIGNMENT PROCEDURES (S-9's with Two 2SC1969 finals) (S-9's with Two 2SC1969 finals) (S-9's with Two ERF-2030 finals) (S-9's with Two ERF-2030 finals) DIAGRAMS PCB Layouts Main (9821R17) PCB Layout Top (2SC1969 Version) (PCBX-0334R3A) ( PCBX-0333R3) (PCBX-0335R3) (PCBX-0416R1) ( PCBX-9709R1) (PCBX-9612) (PCBX-0322) Mode Sel. Rotary Switch PCB (PCBX-0212) ( PCBX-0319R4) ( PCBX-9306) ( PCBX-0309R3A) (PCBX-0415R1) (PCBX-0406) Also See: Magnum S-9: 50W radio with 3 ERF2030s (1 driver & 2 finals) Note Early Versions of S-9's had Two 2SC1969 for finals. Magnum S-9NX: NitroXpress version. 50W radio with 3 ERF2030s (1 driver & 2 finals), and Blue Nitro Knobs. S-3NX Pictures and (available through all Magnum distributors, and available for both S-6 and S-9 radios).

12-19-05 Mic Wiring Stock 1-Shield (ground) 2-Yellow (audio) 3-Red (transmit) 4-White (receive) Astatic 1-Shield & Blue 2-White 3-Red 4-Black Yellow NC Turner 1-Shield & Red 2-White 3-Blue 4-Black Yellow NC Sadelta 1-Shield 2-White 3-Brown 4-Green.

Free Magnum Radio Communication help. Manuals & Customer Service for Magnum Radio Communications. Autocad Mep 2013 Hangers Unlimited. Magnum S9 Base CB Radio. Magnum S980 Nitro - Magnum S 980 Nitro. Cb Radio Tuning, Echos, LED's. Magnum Radio - Owners Manual and Schematic.

• MAGNUM S-9 AM/FM/SSB 10 METER MOBILE AMATEUR TRANSCEIVER OPERATING MANUAL. • LIMITED WARRANTY Magnum International warrants this product to be free of defects for a period of one (1) year from the original date of purchase.

This warranty is non-transferable. This limited warranty is subject to repair or replacement of defective components only. Electrical Connections suited for this purpose. The base loaded whip antenna The Magnum S-9 is designed to work on any 12 - 14.1 normally provides effective communications. For greater volt DC, negative ground, source. The condition of a range and more reliable operation, a full quarter wave vehicle’s electrical system can affect operation.

• In such cases, an alternator/ ignition noise filter can be used. The PLF-10C FilterCord by Magnum International is designed for use with the Magnum S-9 and is an effective way to eliminate alter- nator and ignition noise problems.

• Microphone wiring is as follows: PWR: Variable RF Output Power. The transmitted power Pin 1: Ground of the Magnum S-9 may be varied from 0 to 40 watts Pin 2: Microphone Audio peak in all modes. Rotate clockwise to increase RF Pin 3: Transmit output power.

A PA horn jack is located on the rear panel of the trans- ceiver. The Magnum S-9 is designed to accept any stan- 11. DIMMER LO-MED-HI: The 3 stage dimmer control al- dard PA horn for use with two-way transceivers. • GENERAL SPECIFICATIONS Antenna Impedance: 50 ohm, unbalanced Frequency Control: Digital Phase-Lock Loop (PLL) Synthesizer Frequency Accuracy: Better than +10 ppm from 0 - 40 C after 15 min.