Does it require factory reset? Headwind Sms Communicator Serial. Alex, I did a factory reset first, then loaded the new firmware, powered it down, then powered it up again and setup. I had some issues not being able to call out via the PSTN on a TB and a test Astlinux setup I am trying out at the moment no matter what I tried it would not work, once I reflashed the new firmware and put in the same setting as before all worked well with the first go. I have since upgraded the firmware on a standalone unit which was a real thorn in my head for a few years and no echo not a bit did not have to tweak anything. Happy chappy here. Hope this helps Good Luck Cheers Cleve Edit: here is the post I made before the firmware upgrade. I think I've worked it out.

Where is the SPA3000 firmware? Thank you for your. SPA-3000 Software Version: 3.1.10. There is also a link to anonymous downloads for Linksys products that. Home Support Guides NodePhone Sipura SPA 3000. This guide has been prepared with Sipura firmware version 3.1. Available from the Internode File Download Mirror. Forum discussion: My current Sipura 3000 has the following version Software Version: 3.1.10(GWd) Hardware Version: 2.0.1(7067) I am trying to locate the 3.1.18 or 3.1. To upgrade the firmware in your SPA-3000 download the.

I had my PSTN dialplan1 as: Dial Plan 1: (S0) for example - it could be your phone number And that was working fine for inbound calls but not outbound. Whenever I dialed #0 and the number, it always came up as if I was dialing on the status page. When I change PSTN Dial Plan 1 to (xx.) then outbound calls work, but inbound calls dont (The SPA Answers and gives me a dialtone instead!) 4.2.5. Determining the Availability of the PSTN line SPA determines that the PSTN line is not available if the one of the following conditions is true: - PSTN line is not connected (loop current is 0 or Tip/Ring RMS voltage is below 1V) - PSTN line is being used by another extension. Tip/Ring RMS voltage lower than the threshold set in - PSTN line is ringing - PSTN line is being used by the SPA to serve another VoIP caller If the PSTN line is not available, the PSTN gateway function will be rejected; any VoIP caller requesting PSTN gateway functions will be turned down with a “Service Not Available” response. Last night I upgraded the firmware from.10 to.18 over wireless and without doing a reset. All went well and I can make all outgoing calls OK.